Main > Project Announcements

Critique my cab...

(1/3) > >>

Unstupid:
I have been working on a new cab design on and off for the past month and I want to throw it out there for you guys to critique.  It's going to be a really small (but completely playable) cab running a 60-in-1.  Dimensions are approximately 16"x16"x12.5".  I plan to start cutting tomorrow, but before I cut I just want to know... Whaddya think?

Well Fed Games:
I like it. I assume the square on the front is the speaker grill?

Le Chuck:
Are the sides 3/4"?  They look a bit over thick for the size.  Perhaps 1/2" is worth a look. Other than that it looks sharp.

Unstupid:

--- Quote from: Well Fed Games on October 10, 2012, 11:26:51 am ---I like it. I assume the square on the front is the speaker grill?

--- End quote ---
Yes that is 2.5" speaker and grill

--- Quote from: Le Chuck on October 10, 2012, 11:35:07 am ---Are the sides 3/4"?  They look a bit over thick for the size.  Perhaps 1/2" is worth a look. Other than that it looks sharp.

--- End quote ---
Yea everything is 3/4" combicore.  I need it to be heavy enough to not move around when someone is pulling and tugging on the joystick.  Rule #1 when I was designing this cab is that is has to actually be playable...  ;)

shponglefan:
Not bad.  Only real comments/critiques are:

1) Will there be enough space where the speaker is located to house a joystick?
2) I'd try to make the speaker location flush with the front in the contruction.

Navigation

[0] Message Index

[#] Next page