| Main > Main Forum |
| Will I ever find a coin door to fit this hole? |
| (1/5) > >> |
| Purple Tophat:
Just bought this cabinet on Craigslist. I like everything about it except for the massive hole for the coin door. I'm just worried I'll never find a door that will fit and look ok for a decent price. Obviously I can always cut a new panel, but I'd like to avoid that if possible. Does anyone know if I might have any options? The dimensions of the hole are roughly 21 X 12 and a half. Any thoughts??? |
| Purple Tophat:
Correction, just went down to the garage to measure, and I corrected the measurement above. It's roughly 21" X 12 and a 1/2". |
| TalentedM:
http://www.quarterarcade.com/Game.aspx/10147 I found something so close. It says it is measured "20 1/2" tall by 10" wide". I haven't been able to find something exactly that measurements. I hope you can find something and I will try to keep this in mind while searching around. |
| PL1:
This could be it, but you might prefer buying a different cabinet rather than getting the Over/Under Wide Bill Validator Door w/Cashboxes and Full Metal Enclosure new from SuzoHapp for $266.50 + shipping. Opening size appears to be 12.19" x 20.58". You might be able to post on KLOV's Videogame - Wanted Forum to see if anyone has one. Didn't see anything during a quick glance at the Videogame - For Sale Forum. Scott |
| paigeoliver:
Get a smaller coin door and some black speaker mesh and construct something that fills the hole correctly. |
| Navigation |
| Message Index |
| Next page |