Main > Main Forum

T-molding with lip(s) question

Pages: (1/1)

Frostillicus:

Is there a specific t-molding that people have experience with that has a lip on one side or both, for the front of a control panel with artwork?  I've seen some at various online stores but my experience is limited to straight up 3/4" t-molding with a slot cutter.

This is the limit of my experience...http://groovygamegear.com/webstore/index.php?main_page=product_info&cPath=75&products_id=221

Of course they are sold out - http://www.t-molding.com/store/product.php?productid=16
But assuming they had it in stock, would that fit 3/4" plywood and use the same slot bit as the other link?


Dawgz Rule:

I hate to answer a question with a question but are you concerned the artwork is going to peel?  I would tend to think that the lip will make it uncomfortable if you are resting your arm/wrist on the panel.  Some people opt for a smaller thickness for the control panel and add plexi on top to protect the artwork.  The combined thickness works out to 3/4 of an inch.   If your panel is already 3/4 of an inch you can offset the slot for the t-molding and accomplish the same thing...just round the bottom edges. 

Frostillicus:

That is probably a better idea... I didn't think of comfort factor.
Thanks!





PL1:

The other approach is to wrap the art around the edge and cut it at the edge of the t-molding slot allowing the t-molding to hold the edges of the art down like Rikitiki does in his stickied "side art install 101" thread.


Scott

paigeoliver:

You are probably going to want to use plexi if you are going with custom printed artwork anyway. I HATE plexi, but I still use it whenever I am not using silk screened artwork.

Pages: (1/1)

Go to full version