Main > Project Announcements

Time to go Full Size - LASER cut Acrylic bartop

<< < (6/9) > >>

dextercf:
I need to get my friends with someone locally which has access to something like this.. damn!
There is no end to what I could come up with..

selfie:
When I got the 100 in 1 board there was a loose wire on the MB at the VGA "connector" I took it back and had it soldered up but when I fired it up I got a really bad signal, flickering, lost colours then nothing... I took it back again and grabbed a 60 in 1 board.

There is now a bit more room inside.


The bottom got closed up, the masking got peeled off, I cut a joystick dust washer to match the sides, a few marks got polished off and other than labelling the coin and start buttons we are done.











I took it home and fired it up and my wife's response was "That's f__kin cool!"   ;D ;D ;D

I will be taking it to my brother's engagement party on the weekend and hopefully someone will offer me some money for it ;)

pinballjim:
Looks great but that is some mega overkill on that power supply, dude. 

selfie:

--- Quote from: pinballjim on October 04, 2012, 05:49:59 pm ---Looks great but that is some mega overkill on that power supply, dude.

--- End quote ---

I know but it's what I had :dunno

rablack97:
All that work...and PBJ is looking at the power supply..... :laugh2: :laugh2:

 :applaud: :applaud:Great job man....although i thind you used too much plastic... :dunno

 :cheers:

Navigation

[0] Message Index

[#] Next page

[*] Previous page