Main > Everything Else

What to do with leftover parts...

(1/4) > >>

Nephasth:
I had a couple meters of RGB LED strips leftover from the cabinet lighting on the Beast, so I decided to put some of it to use. I've been wanting floor lights in my Tundra for a few years, and this was the perfect excuse to make some.

Under the glove box off:


Under the glove box on:


Switch with headlights off:


Switch with headlights on:


View from the back seat with floor lights off:


View from the back seat with floor lights on:


View from outside driver's door:


Really impressed with how these turned out. They're hard wired for red only right now, but I can make short (about 1" long) harnesses to put between the strip connector and harness connector to light them up one of 7 colors. Had to buy the switch and Add-A-Circuit fuse for a total of about $17 and a couple hours for this little project.

What do you do (non arcade related) with your spare parts?

yotsuya:

--- Quote from: Nephasth on September 18, 2012, 10:33:28 pm ---What do you do (non arcade related) with your spare parts?

--- End quote ---

Put them in a box and tell my wife I' m going to use them later!  :cheers:

the_gamer:

--- Quote from: yotsuya on September 19, 2012, 12:40:18 am ---Put them in a box and tell my wife I' m going to use them later!  :cheers:

--- End quote ---
The keywords in this post are "tell my wife"  :laugh2: mmd  :cheers:

lordnacho:

--- Quote from: pinballjim on September 19, 2012, 12:15:55 pm ---Tundra?  Must be nice.

--- End quote ---
Deja vu?

HaRuMaN:

--- Quote from: lordnacho1 on September 19, 2012, 12:32:46 pm ---
--- Quote from: pinballjim on September 19, 2012, 12:15:55 pm ---Tundra?  Must be nice.

--- End quote ---
Deja vu?

--- End quote ---

PBJ suffers from Tundra-envy.   ;D

Navigation

[0] Message Index

[#] Next page

Go to full version