| Main > Main Forum |
| How to make hollow shaft |
| << < (2/3) > >> |
| SavannahLion:
If I may ask.... What kind of illumination are you trying to do? Single color, RGB? Running one wire is a different and (IMHO) easier than trying to run the three for RGB. |
| gamepimp:
Here's a good article on adding LEDs to the U360... http://forum.arcadecontrols.com/index.php?topic=108490.0 |
| Mysterioii:
--- Quote from: gamepimp on August 23, 2012, 07:43:21 am ---Here's a good article on adding LEDs to the U360... http://forum.arcadecontrols.com/index.php?topic=108490.0 --- End quote --- You know, I had read that, but forgot about it. :cheers: |
| cammada:
I am trying to set up blue illuminate joystick. I have contact Paradise Arcade shop about the dimension of the hollow shaft they are selling but I never got any reply back about it so I decide to forget them because there is no way if I buy the shaft then find out it not compatible. So I thought I would take the hard step and find the workshop that have metal lathe then try to drill the hole, I am hoping to get 2mm hole so a single color can fit through as I don't want RGB color. I am aiming to use Ultimarc's Servostik joystick. I am still looking around for hire or services......... |
| iscariot:
Any steel shop should be able to do it. If you;re in the Marietta, GA area there;s a place on Canton that has the equipment to turn them out. It'd probably take a few mins but they charge by the hour. |
| Navigation |
| Message Index |
| Next page |
| Previous page |