Main > Main Forum

Wiring a mouse hack spinner

Pages: (1/1)

ceburto2:

I am creating a spinner from a mouse PCB and other parts. I would like to wire the mouse microswitches to standard game button microswitches. I believe this would enable me to skip the encoder for the spinner. How do I identify the three legs of the mouse microswitches?

Thanks,
Ceburton2


PL1:

There's probably no third lead -- look under the switch.

If there are, use a multimeter in continuity/ohms mode to determine which two leads under the switch are normally not connected (no continuity/open), but are connected when the button is pushed.


Scott

Pages: (1/1)

Go to full version