| Main > Main Forum |
| Mame conversion of a Pole Position cabinet |
| << < (3/4) > >> |
| TGov:
I just picked up a PP cab and I think my brother is going to MAME it. There is a ton of room for CP controls and also room for a 27" CRT in there. Should be a pretty good MAME cab. |
| Malenko:
--- Quote from: TGov on October 03, 2012, 01:21:40 pm ---I just picked up a PP cab and I think my brother is going to MAME it. There is a ton of room for CP controls and also room for a 27" CRT in there. Should be a pretty good MAME cab. --- End quote --- theres JUUUUUUUST enough room for a 27" |
| ChadTower:
--- Quote from: Malenko on August 13, 2012, 03:25:54 pm --- --- Quote from: mappler on August 13, 2012, 02:06:30 pm ---Only room for one cabinet.. ;) --- End quote --- I have a PP cab, it'd be terrible for anything other than a driving machine without a buncha work to the CP area. (cept maybe a shooting cab) --- End quote --- I have one too. It only makes a good MAME cab if you remove the wheel entirely. That wheel is way too big to share the CP with anything else. With no wheel you could make a decent mame cab out of it so long long as you don't stick 500 buttons on it. |
| cw:
I have a pp that needs a home here in Austin Tx... not a bad looking shell... and it solid. |
| paigeoliver:
Have one available in St. Louis as well. --- Quote from: cw on October 03, 2012, 05:06:45 pm ---I have a pp that needs a home here in Austin Tx... not a bad looking shell... and it solid. --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |