Main > Project Announcements
Scratch - Marvel v Capcom: Revolution - Complete with tour video
rablack97:
That's expensive bit for 3 holes.
Get a scrap piece and use the layout template, cut the holes and then cut the acrylic using that as a jig, then finish off the rest on the master CP..
Edit: Oh if you already have the bit, then your cool!!!! Just don't slip, thats a small area to keep that bearing on.
griffindodd:
Aye, I'll use the extended offset base attachment on that cut, plus I'll go from the back of the CP with the plate on the opposite side to put a little distance between the cut and the bearing.
mcseforsale:
Just be careful. Having 3/4" between the cut and any underlying surface can create chatter and cracking. Plexi is an unforgiving mistress.
AJ
--- Quote from: griffindodd on October 22, 2012, 12:48:57 pm ---Aye, I'll use the extended offset base attachment on that cut, plus I'll go from the back of the CP with the plate on the opposite side to put a little distance between the cut and the bearing.
--- End quote ---
rablack97:
--- Quote from: griffindodd on October 22, 2012, 12:27:34 pm ---
Another thing I thought about during our dust-washer discussion...
For those people who under-mount the sticks and have their 1"1/8 hole coming through the wood - you could wrap some LED ribbon inside the edges of the hole in the wood and then put a thin white/translucent dust washer over it then mask that with art and acrylic on top. This way you would get a really nice lit area around the base of your stick. You could do it RGB and run it to your PAC64 to be extra fancy.
--- End quote ---
Sick aint it, ala OND.
griffindodd:
yeah that's the effect, a slightly different execution but that's the idea. I may have to try and work this into my sticks.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version