Main > Main Forum

A (rare) Craigslist Success Story

Pages: << < (10/18) > >>

HaRuMaN:

The game plays perfect.  Haven't checked the dollar bill validator yet, but the coin door works on tokens.

Unfortunately, I can't grab any toys because of the black sheet covering everything up.  Now, I just have to defeat this lock somehow:



Any ideas?  It looks like it would be a royal pain in the  :angry: to drill.

Le Chuck:

Now is a great time to revisit the lock picking thread!

[Wayne's World flashback noises]http://forum.arcadecontrols.com/index.php?topic=119173.0[/Wayne's World flashback noises]

Man, that wasn't actually that helpful.  You should get this:  http://www.dhgate.com/wholesale/tubular+lock+pick.html

or go read this:  http://www.analoghacking.com/documents/ftw/FTW%20Defeating%20Tubular%20Locks.txt

Or use some freon to freeze the lock and whap it really good with a screw driver and hammer

Or just try drilling it out and be amazed at how fast a good sharp bit will chew through the lock.  Start small and work larger until you're through. 



Dervacumen:

Nice find.  Put all of your kid's stuffed animals in the crane, set it to the most difficult setting, and tell her she can play with them when gets them out.  Keeps toys off the floor.

HaRuMaN:


--- Quote from: Dervacumen on July 05, 2012, 12:07:48 pm ---Nice find.  Put all of your kid's stuffed animals in the crane, set it to the most difficult setting, and tell her she can play with them when gets them out.  Keeps toys off the floor.

--- End quote ---

LOL...  ;D

HaRuMaN:

So...  I've been drilling on the lock... haven't had a whole lot of luck yet.  Here is the same lock, removed from the coin door (luckily the coin door was open, so I could get it off):



If you can see, it has a little metal tab that sticks up through the housing:



If I push on the tab so that it goes all the way in, the front face of the lock pops out (it's spring loaded) and I can turn the handle.

I've drilled enough of the lock to reach the arm that the tab is on, I can pull it down, but the face isn't popping out yet.  I'm thinking maybe I'm just not able to pull it all the way down, and maybe some more drilling will fix that.

Anyone else played with this type of lock?

Here is the manufacturer:




Pages: << < (10/18) > >>

Go to full version