| Main > Project Announcements |
| Sega Blast City Revival - Done |
| << < (13/17) > >> |
| dgame:
The dust washer that came with the U360s does not lay flat throughout the entire range of motion. One side tilts up and the other side scrapes down. It clacks and gets in the way during play. I also like the look without them. Since this is for home use only I don’t think it will be a problem. BUT since you asked I did some research and read about hands getting pinched by U360s with metal control panels and no dust washers. So the plan is to look at what needs to be done to the existing dust washers and either mod them or contact TEFightStands for some custom dust washers. It may be as easy as slightly widening the center of the existing dust washers to keep them lying flat. Thanks for the feedback. |
| dgame:
I used a pen wrapped in sandpaper to ream out the center of the dust washers and now they stay flat. The center ended up being about 2 millimeters larger than stock. Thanks for bringing it up. |
| rCadeGaming:
Nice. Such an awesome CP. |
| dgame:
Thanks. I enjoy learning new things while working on this as much as playing the games. I wired the bill acceptor to the harness so it can be used with real PCB (triggers JAMMA 16). I also received the 5 volt relay module and wired it up to the JAMMA fingerboard. The result is that the coin switch (JAMMA 16) also triggers the 12 volt coin counter (JAMMA 8 ). I did this because the 12 volt coin counter wired in parallel with the coin switch does not work with the 5 volt zener diode used to protect the U360. I also wanted this mod to be easily removable for PCB use. |
| harveybirdman:
Just popping in to say this is awesome and I'm jealous. |
| Navigation |
| Message Index |
| Next page |
| Previous page |