| Main > Main Forum |
| Using a PACLED to control cathode tubes? |
| << < (3/3) |
| TheShaner:
I would assume that you could because of the nature of the strip, but thanks for asking Neph! I am no electrician,so please someone chime in! I was thinking of doing some LED rope light under the cab for the glow. Pulsing that with the LED marquee, buttons and joysticks would be sick! |
| rockyrocket:
Hi, this sort of thing is commonly done with pincabs (LED strips) although usually with a ledwiz but that is not an issue. As an example check this out... http://www.hyperspin-fe.com/forum/showthread.php?13146-Big-Bang-Pin-46-30-15-6-LED-Widebody-%28custom-artwork-bezel-less-deep-playfield%29/page61&highlight=bang The same three outputs are controlling both an RGB flipper button x2 and then also a 12v RGB strip, i myself have a matching set up with four 5v button LED`s and a 12V RGB strip all from 3 ledwiz outputs. Hope this helps. |
| Navigation |
| Message Index |
| Previous page |