| Main > Main Forum |
| Damaged PCB? |
| << < (4/4) |
| EvilGreenDevil:
Quick update: Replacement Lono2 came in (with cookies) and it works perfectly. My only concern is I'm scared to fry the board again. At this point i just have the push buttons connected to the Lono2 and not the LEDs. what I was planning on doing was have the LEDs and signals run on separate circuits, completely ignoring the EZ-off option. So: Microswitches signal/ground ----> Lono2 12v LED lights power/ground----> PC Power supply both are separate so I don't see there being an issue but figured I would ask just for some reassurance. thanks |
| PL1:
You should be fine as long as you don't short the 12v to the Lono2. . . but you already know that part. >:D Scott |
| Navigation |
| Message Index |
| Previous page |