| Main > Main Forum |
| Question regarding arcade control wiring. (cn4 + cn5 and cn6 +cn7) |
| (1/1) |
| AdamL:
Hey im kind of new to the hole arcade thing and I have run into a problem. I have purchased a 4 player cabinet with the game atomic punk 2 ''global quest''. apart from the jamma harness there are 2 connections ''3p'' and ''4p'' both with markings on the pcb of cn4 and cn5. My question is regarding the compatibility of this game with the simpsons arcade. Currently I have hooked up the game with the jamma harness and i get distorted picture and sound. The slots where the 3p and 4p would have labels cn6 and cn7 and are longer. What can i do to get my game working? If it matters my game is currently wired to take a quarter from ethier coin slot and you hit a button over the desired character to play. Any help would be appreciated. |
| Crazy Cooter:
Simpsons: http://www.arcade-museum.com/game_detail.php?game_id=9550 Atomic Punk Global Quest: http://www.arcade-museum.com/game_detail.php?game_id=6969 Look at manuals & pinouts for each |
| runawayabc123:
Konami pin out for players 3/4 ("3" shown below for player 3): 1 Coin 3 Violet/Stripe 2 Empty N/A 3 3 Player Left Red/Stripe 4 3 Player Right Yellow/Stripe 5 3 Player Up White/Stripe 6 3 Player Down Blue/Stripe 7 3 Player Push 1 Brown/Stripe 8 3 Player Push 2 Orange/Stripe 9 Empty N/A 10 Empty N/A 11 Empty N/A 12 Empty N/A 13 Empty N/A 14 Coin 3 Ground Black 15 CP Ground Black The grounds all go to the same place (ground), so you can wire 14/15 however you want, or not even use them at all if you don't want too. WARNING! These are 2.5mm connectors, not 2.54mm connectors. (mertic vs custom) and I had to buy a TON of them to get the correct ones. (Most min buys are 200, but I lucked out with 154 as that was all they had left instock!) The only other places without min buys weren't in the US and charged a ton for shipping. PM or email me if you are interested in pair of connectors and contacts (no wire, must be assembled). |
| Navigation |
| Message Index |