| Main > Main Forum |
| Configuring U360 joystick? |
| (1/2) > >> |
| P-chan:
Ok, so I got my control panel all wired up, I have joystick #1 and #2 assigned different ID's as per the directions on the Ultimarc site. However, I have a few issues/questions: 1) How do I re-map the joystick to recognize the correct directions? Obviously I could unscrew the circuit board and rotate it, but for instance, my joystick #1 shows up as moving left when it should be pointing down. 2) How do I tell the joystick there is an octagonal restrictor installed? The Ultimarc site says that there is an option for it in the UltraMap software, but this is what I have: 3) How do I configure a front end (or MAME itself) to automatically load maps upon game selection? For instance, if I select "Galaga" the joystick should recognize that it needs to be in 2-way mode, or 4-way mode for pac-man, for instance. I can tell on this page : http://ultimarc.com/ultrastik_prog.html how do possibly do it with MAMEwah, but what about other frontends? Thanks everyone! Also, I would suggest getting some Windows 7 instructions /screenshots up there, things are a little different in the control panel than they were 10 years ago :) |
| P-chan:
Bump. 25 views and 0 replies? :( |
| bbee383:
1) Easy way is to rotate the board....Its only 4 screws. 2) I believe the Circular is the same at octagon. 3) LEDblinky can take care of this. You do not need to have any LED's. The software has a check box to use the u360's and it will load the right maps in you frontend. Hope that helps. |
| AndyWarne:
Note you can check the board is the right way as it has "Top" marked on it. But you can rotate the faceplate also. It might be easier. 4 screws on the front of the plate. Andy |
| P-chan:
Thanks bbee383! I guess you're right, it's only 4 screws, lol. I will check out LEDBlinky, thanks for the suggestion! |
| Navigation |
| Message Index |
| Next page |