Main > Main Forum
Marquee retainer options
<< < (7/8) > >>
Nephasth:
I'm looking for something for a very similar application. I'm trying to find 45 degree (inside angle) stock, channel, corner gaurd, whatever; in lengths of 4 feet or more. Hell of a time trying to find this ---steaming pile of meadow muffin---. I'm almost ready to buy small 45 degree brackets and just bolt flat stock onto them, but I'm wanting a clean finish... The search continues...
mcseforsale:
Here's the build thread.  Definately have about a 45 on the bottom marquee retainer.  Just click the vid links...

http://forum.arcadecontrols.com/index.php/topic,117977.0/all.html

AJ
Tonyjambo:
Pics as promised - sorry for the poor quality - lighting conditions are intentionally dark iin my basement :)
Was funny that the screws showed so much on the speaker panel in the pics - you cant see these at all when you're playing.

TheShaner:

--- Quote from: Tonyjambo on August 08, 2012, 08:44:36 am ---Pics as promised - sorry for the poor quality - lighting conditions are intentionally dark iin my basement :)
Was funny that the screws showed so much on the speaker panel in the pics - you cant see these at all when you're playing.

--- End quote ---

Nice, you have the plexi of your marquee attached to a hinge?
Tonyjambo:
Nahh - it just looks like that, but that might be a good mount option for the folks with odd angles just hinge it on the inside  - mine is just hanging off the velcro.  I got quite creative on my marquee in general with lots of velcro and duct tape to prevent light bleed etc.

I did try it with little neodynium magnets to hold the marquee in place but the light bleed was too bad, the velcro acts as quite a nice gasket to prevent the light slipping out around the edges.
Navigation
Message Index
Next page
Previous page

Go to full version