| Main > Main Forum |
| Fake coin door |
| << < (3/3) |
| matsadona:
--- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door... --- End quote --- Isn't this forum about building things just because you can? ;D |
| JayB:
Put a kids toilet seat on instead ;D |
| Mysterioii:
--- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door... Mikesarcade has a full 2 slot door with mech and everything for $65. --- End quote --- Not seeing it on their site? I see mechs but not full doors.... out of stock maybe... |
| Unstupid:
--- Quote from: Mysterioii on May 03, 2012, 08:09:14 am --- --- Quote from: Unstupid on May 02, 2012, 08:51:44 pm ---For what it would cost to do something like that you could buy a real door... Mikesarcade has a full 2 slot door with mech and everything for $65. --- End quote --- Not seeing it on their site? I see mechs but not full doors.... out of stock maybe... --- End quote --- Sorry... It was from twistedquarter.com and it was $69.99. But they have others cheaper... ;) |
| Le Chuck:
If you're working 1:1 scale you could use 1/8th inch project board and route the raised outline of say an Atari over under then round all edges and glue that down to a template. The coin drops and returns could be carved very easily in the same manner. If you're working smaller then there are a lot of options, Bender uses styrene and I favor aluminum for mines. |
| Navigation |
| Message Index |
| Previous page |