| Main > Main Forum |
| DIY arcade joystick w/arcade parts for $60 |
| << < (3/6) > >> |
| CthulhuLuke:
*Bump* Wow this thread tired fast -___- oh well |
| Ahi_Tuna:
For $5 you can also get enough acrylic to cut two new top covers to replace the Redoctane ones with the funky graphics. |
| slicer_d:
--- Quote from: Ahi_Tuna on September 30, 2003, 07:23:41 pm ---Supers will bottom out on a Redoctane case. You're better off with a competition or ultimate. Competitions sit a little lower than I like though (about 1/4" too low) I'll get flamed for this but Ultimates fit in there perfectly. --- End quote --- Correct me if I'm wrong here but dont comps and ultimates stick out at the same height from the base 3.66in? |
| OSCAR:
--- Quote from: slicer_d on October 13, 2003, 10:44:16 pm ---Correct me if I'm wrong here but dont comps and ultimates stick out at the same height from the base 3.66in? --- End quote --- Not quite. The dimensional info that Happ has on the Comp is not accurate. I measured the Comp @ 3.4", which is about a 1/4" shorter than the Ultimate. |
| slicer_d:
Cool thanks for the info I was just looking through your website good stuff. I'm either going to try routing out some of the redoctane box or dremel it so I can get the comp up a little higher. Keep up the good work Slicer_D |
| Navigation |
| Message Index |
| Next page |
| Previous page |