| Main > Main Forum |
| Frustrating i-pac problem |
| (1/1) |
| .trunzx:
I'm having a strange issue with my I-pac4 that I cannot figure out. Basically I have a 4 player setup, 1 joystick for each, 6 buttons for players 1 and 2, and 3 buttons for players 3 and 4. Each player also has a start button. Anyway my issue is that whenever I try to map the controls I will have 2 buttons bound to 1 key. For example my player 1 UP will also trigger player 3 button 2. Usually its an arbitrary key like J that is bound to 2 of my switches. I've tried programming the ipac but that doesn't seem to work. I have quadruple checked my wiring and it's all in good order. I'm all out of ideas at this point. Anyone have any suggestions? |
| MTPPC:
Make sure your ground is really good. Figure out why your i-pac4 won't program. There have been a few duds from what I have read, but most of the time complaints are operator error. If it was a Chinese junk board, I'd blame the board first, but j-pac and i-pac seem to have better quality control. |
| .trunzx:
--- Quote from: MTPPC on April 24, 2012, 12:07:10 am ---Make sure your ground is really good. Figure out why your i-pac4 won't program. There have been a few duds from what I have read, but most of the time complaints are operator error. If it was a Chinese junk board, I'd blame the board first, but j-pac and i-pac seem to have better quality control. --- End quote --- I'll check the grounds again, I have players 1 and 2 on 1 ground, 3 and 4 on another ground. I should mention that I had it working once by dumb luck. I unplugged it, put it back and programmed and somehow it was fine. Too bad I had to reformat :(. Now, no matter what I do it will always assign 2 switches to 1 keyboard key. |
| alfonzotan:
Has that card always worked properly? A while back several IPAC4's were shipped out accidentally with IPAC2 firmware installed... I got one of them. Nothing worked until it was flashed with the correct firmware. |
| AndyWarne:
--- Quote from: .trunzx on April 23, 2012, 11:49:54 pm ---I'm having a strange issue with my I-pac4 that I cannot figure out. Basically I have a 4 player setup, 1 joystick for each, 6 buttons for players 1 and 2, and 3 buttons for players 3 and 4. Each player also has a start button. Anyway my issue is that whenever I try to map the controls I will have 2 buttons bound to 1 key. For example my player 1 UP will also trigger player 3 button 2. Usually its an arbitrary key like J that is bound to 2 of my switches. I've tried programming the ipac but that doesn't seem to work. I have quadruple checked my wiring and it's all in good order. I'm all out of ideas at this point. Anyone have any suggestions? --- End quote --- For any problems with our products its best to drop me an email at andy@ultimarc.com, we can usually sort things very quickly. Andy |
| Navigation |
| Message Index |