| Main > Project Announcements |
| Vigolix, a super easy mini cab on 1 sheet of 2X4 plywood |
| << < (4/28) > >> |
| Generic Eric:
Great. Menards has precut 2' x 4' sheets of mdf for about $8.00 (if I remember correctly) Fits well in the back seat of a gran prix. |
| Nephasth:
Isn't this thing done yet? ---steaming pile of meadow muffin---, you've been working on it in your sleep! ;) That's one lucky son you've got there! :applaud: |
| 404:
Since i'm basically stuck at work, i'm going to make a quick sketch of the board. I'll put it up when i'm done. |
| Vigo:
Thanks again everybody! :cheers: --- Quote from: 404 on April 17, 2012, 03:38:31 pm ---Since i'm basically stuck at work, i'm going to make a quick sketch of the board. I'll put it up when i'm done. --- End quote --- Awesome! Please do! :) --- Quote from: Generic Eric on April 17, 2012, 02:19:02 pm ---Great. Menards has precut 2' x 4' sheets of mdf for about $8.00 (if I remember correctly) Fits well in the back seat of a gran prix. --- End quote --- That's not bad, I think it was about the same for the 2x4 plywood I bought from Menards. Had I known when I bought the wood that it was going to be an arcade cabinet, I might have went with MDF. |
| 404:
--- Quote from: Vigo on April 17, 2012, 03:54:03 pm --- --- Quote from: 404 on April 17, 2012, 03:38:31 pm ---Since i'm basically stuck at work, i'm going to make a quick sketch of the board. I'll put it up when i'm done. --- End quote --- Awesome! Please do! :) --- End quote --- Happen to know the dimensions for the jut you cut out at each side? Also, i started the draft using a 4x8 piece of wood in mind to make a full sized cab. Before i started actually drawing out the cab i thought that i would simply double up the measurements. Physically drawing this out proves that this would be greatly disproportionate for the average human to play. While a 32inch control panel is feasible,the vewlix by default also uses a large, wide screen monitor however a cabinet with an 8 foot height from tip to tip is not. If you had actually envisioned this using a 4x8 piece of wood, what dimensions would you use? |
| Navigation |
| Message Index |
| Next page |
| Previous page |