| Main > Lightguns |
| Namco Time Crisis II Light Gun conversion to aimtrak recoil questions |
| (1/1) |
| starwarsfan54321:
Does anyone know how to wire recoil into the aimtrak as well as how to power it, I read that it needs 24vdc? I recently bought two two namco light guns for a good price off ebay and about to order some aimtraks so I wanted some advice before they come. |
| Donkbaca:
You are going to have to wire it separately, there is only 5 volts available on the Aimtrack board |
| BadMouth:
Not a simple thing. http://forum.arcadecontrols.com/index.php?topic=108256.0 There are other ways. Andy has a firmware that triggers an output on one of the Aim-Trak pins when you fire on-screen. http://forum.arcadecontrols.com/index.php?topic=109142.0 I tried to use this method with a transistor acting as a relay, but the 24v overwhelmed the recommended transistor and it would stay on. I got a bigger transistor and the output from the Aim-Trak was either too weak or too short to trigger it. (I'm not that knowledgable about electronic components) I decided that I would use an LEDwiz to trigger the transistor instead, but after messing around with the aim-trak for a while, I just can't get it calibrated accurately enough for my taste. It would be ok if using on-screen crosshairs, but using only the gun sights results in too many missed shots. As far as the power supply goes, just look up 24v power supply on fleabay. I believe the one happ sells for gun recoil are 6 Amp. |
| Donkbaca:
My aimtraks are wired up to little vibration motors, so it shakes when I pull the trigger, kind of like an Xbox 360 rumble. I have given up on the Aimtraks for now though. I could NOT get my second gun to calibrate at all, it became really frustrating. Good luck |
| Navigation |
| Message Index |