Main > Main Forum
Wiring troubles
(1/2) > >>
dprush83:
Tonight I wired up my control panel, I was very excited to test the inputs before loading a game. In the game I found an issue with my UP button, though. The input goes through, but only one quick up motion and then the input ceases even if I hold up. For Mario to go up a ladder in DK you have to hit up 4-5 times.

I thought it was a loose connection, but after trying a few adjustments I got a new wire and even needle nosed the wire directly to the prong...still the same issue.

Anybody know what might be causing this??
Louis Tully:
.
mytymaus007:
what encoder are you using? Try another input to see if it that and if its still doing the samething try a different switch
dprush83:
It is being run through MAME, but the problem occurs in other programs too (game selection in Hyperspin).  I'm using an ipac, I rewired that input a couple of times to make sure I installed it correctly.  Good ideas about the switch, I will try that tonight to see if perhaps that is it. 
kahlid74:
I've never had any problems with my IPacs but I would check the switch on the up and then if the problem persists I would give a visual glance over for the solders on the bottom of the IPac board.  Make sure it didn't get damaged possibly.
Navigation
Message Index
Next page

Go to full version