Main > Project Announcements

Bartop/Weecade Clone - COMPLETE (6/8/12)

<< < (5/12) > >>

opt2not:
Cool looking artwork!  :applaud:
Looks like my painting corner in my home office ;)

EvilGreenDevil:

--- Quote from: opt2not on April 10, 2012, 04:58:07 pm ---Cool looking artwork!  :applaud:
Looks like my painting corner in my home office ;)



--- End quote ---

thanks, I think i'm gonna go with clear dust covers that slim in size to show off as much of the artwork as I can.

EvilGreenDevil:
OK so everything is coming along nicely albeit at a steady pace. I finished my final coat of primer and figured I would test fit the PC parts one more time just to make sure before I started putting the topcoat on. I was able to cram everything in pretty well a-la-Tetris which left me pretty happy. The one issue I ran into was that my P1 joystick clips the CP molding by barely 1/4".

Now I'm left with the decision of moving the joystick in (which would also mean moving the buttons and P2 layout in to keep things even) or take to my jigsaw and carve out the small space that I need. The molding is 1" thick which after being trimmed would still be 3/4". Still glued and screwed in, I think it should be fine, I'm just hesitant to start cutting again.





Maybe i'll do both, move the stick in 1/8 of an inch and shave an 1/8" off the molding. Space between each player's layout is at a premium and I'd like to avoid moving any closer.

Richie_jones:
Do you plan on pinball buttons. These will snag to. Had to redo my cp due to the pinball buttons snagin the joysticks

Sent from my GT-I9100 using Tapatalk 2

EvilGreenDevil:

--- Quote from: Richie_jones on April 20, 2012, 03:43:07 pm ---Do you plan on pinball buttons. These will snag to. Had to redo my cp due to the pinball buttons snagin the joysticks

Sent from my GT-I9100 using Tapatalk 2

--- End quote ---

They fit no problem, already checked.

Navigation

[0] Message Index

[#] Next page

[*] Previous page