Hi
Been working on this for a few days and just thought i`d share some progress pics, would appreciate any comments, good or bad!!!
First side cut with a jigsaw using rail guides. Then clamped to another piece of MDF and routered an exact copy using the flush cutting bit..
The two sides with the base and back board
Even though i`m using a full size ATX board and full size PSU, i`m trying to keep the size of the cab as small as possible. This is the reason i`ve decided to mount the speakers in the top panel and not under the marquee.
Control panel cut and ready to mark up for the joystick/buttons
Buttons in place, but suffered some blow out on the MDF so will have to make up a new CP
Dell 19inch Moniter mount in place, I can unhook the moniter from the mount without removing any screws,