Main > Main Forum
First timer, looking at a cab to start my MAME project
(1/2) > >>
JustAskJack:
I been poking around looking at some cabs... to start a MAME project in.

Found this one, good condition, was wondering if there's any known problems with these kinds of cabs that would make this a bad one to use for a starter. ( I know it only has 4 buttons, I was planning on a custom CP down the road, unless that's not possible with this cab)



Thanks in advance
paigeoliver:
That one will work just fine. I wouldn't be surprised if the missing streetfighter 2 button holes were already drilled underneath the overlay (the spacing makes me think they are).
JustAskJack:

--- Quote from: paigeoliver on March 19, 2012, 09:55:03 pm ---That one will work just fine. I wouldn't be surprised if the missing streetfighter 2 button holes were already drilled underneath the overlay (the spacing makes me think they are).

--- End quote ---

Thank you for the reply. What would you consider a fair price for that cab?
Drnick:
I would probably go $150, but then again I am a cheapskate.
kahlid74:
That cab will work fine.  Price wise it depends what you're getting.  If I'm buying a cab with just the coindoors I'm not going higher than $75.  Empty cabs I'll pay $50-75.  If it's got a working monitor and all of the previous stated I'd go $150-200 and if it's a working cab I'd look on Ebay/CL and see what those are going for.
Navigation
Message Index
Next page

Go to full version