Main > Main Forum
Power for Aimtrack IR Sensor Bar
<< < (2/2)
lettuce:
Would a 3rd party wireless Wii sensor bar work with the AimTrak lightgun??
DarthMarino:

--- Quote from: lettuce on February 18, 2012, 05:06:40 pm ---Would a 3rd party wireless Wii sensor bar work with the AimTrak lightgun??

--- End quote ---

No. It's a different layout on the IR lights.
romshark:
However, the Wiimote works very well with the AimTrak sensor bar.
matsadona:
Anything normally powered through USB is 5V with a maximum 500 mA current*. So anything with that specs can be used as an alternate power source.
Note that it has to be 5 Volt, but the current rating could be higher. The circuit will not be “charged” with a 3A current if the power supply rating says 5V / 3A. That only means that the power supply can deliver a current of 3A.

Something like if you buy a $5 item with a $100 bill, you will not be charged $100, just the $5 ;)

* There is USB equipment that has double connectors, and that is simply because the total current need is more than 500mA.
Navigation
Message Index
Previous page

Go to full version