Main > Main Forum
Fixing t-molding slot
<< < (2/3) > >>
BobA:
+1 on hot glue if the slot is oversized or can be made oversized to center the t molding,   
GregD:
 Hmmm.  I think i will try the glue method.  Thanks.
darthpaul:
And I thought I was the only one to use hot glue.
leapinlew:
If you go with the hot glue, how stuck on is it going to be if you need to replace it?
dandare:
if its for a slot that's a bit too big, i found 'blu tac' to be a great non-permanent solution. 

roll into long thin sausages, and push the t-mold in (ooh-er!).

Navigation
Message Index
Next page
Previous page

Go to full version