| Main > Main Forum |
| Fixing t-molding slot |
| << < (3/3) |
| GregD:
I routed the other side of the cabinet by hand. Looks much better. The trick was putting a really big base made of plywood on the router rather than trying to keep tue router straight with small round base. I am going to go through a lot of hot glue before this project is done. |
| kahlid74:
I've found that using a stationary routing table for big cabinet sides just isn't practical. For bartops it works but for full size cabs the only way to go is route it by hand with a plunge router. As for filling a bad router cut it really depends how bad. If you're off by like 1/16 Hot glue rocks. If you're off by 1/4 or 1/8 I like to bondo and completely redo it. |
| Navigation |
| Message Index |
| Previous page |