Main > Main Forum
How build in LCD monitor?
<< < (3/3)
HanoiBoi:
You don't have to drill through the sides of the cab from the outside.

I joined my LCD monitor to a horizontal piece of wood via VESA mount.  The width of the wood matches the width of the inside of the cab.  Then, similar to fenring's photo, I glued and screwed smaller 'blocks' of wood to the inside of the cab, from the inside.  After that, I could mount the monitor/wood to those blocks by screwing wood to wood.

You just have to be sure on your measurements so that your monitor doesn't end up too close or too deep.
Navigation
Message Index
Previous page

Go to full version