| Main > Main Forum |
| Can the Happ/Atari Active Steering Wheel be interfaced to a PC? |
| << < (5/6) > >> |
| isamu:
Mark check you email :) |
| isamu:
Bump :hissy: |
| johnm160:
This wouldn't work with an xbox would it?? |
| mark shaker:
Isamu, If my calculations are correct: The diameter of the Happs Steering Wheel bolt pattern is approximately 1 9/16". The bolts are at the 2, 6 and 10 O'Clock positions. You get to figure-out what will work! If the quick disconnect has 2 parts, one attached to the column and one attached to the wheel, you should be able to drill any holes you need in the column part, as they will not be seen with the wheel in place. - Mark |
| mark shaker:
--- Quote from: johnm160 on October 12, 2006, 02:50:36 pm ---This wouldn't work with an xbox would it?? --- End quote --- Not exactly. Assuming the X-Box supports force feedback (I've heard Yes and No): You could try the same trick with the PCB taken from a XBox wheel. - Mark |
| Navigation |
| Message Index |
| Next page |
| Previous page |