Main > Main Forum
Do all lcd/led tvs/monitors look like this when they are unframed ?
Jasonmm:
--- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS.
--- End quote ---
I got big plans ...
plus
I got CnC fever ...
The TS is great, but its FAR (140 miles round trip/ gas money) and TS fee isnt cheap.
I got in early and got the TS guys all excited about the MechMate.
I am taking 13 classes and going at it ....
I live in my forever home ...
Do it right is my thinking ...
Jason
Woodshop Flunky:
I think the Dallas/Ft Worth metro area would be a very profitable location for a TechShop. 8)
mountain:
--- Quote from: Jasonmm on January 04, 2012, 01:02:08 am ---
--- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS.
--- End quote ---
I got big plans ...
plus
I got CnC fever ...
The TS is great, but its FAR (140 miles round trip/ gas money) and TS fee isnt cheap.
I got in early and got the TS guys all excited about the MechMate.
I am taking 13 classes and going at it ....
I live in my forever home ...
Do it right is my thinking ...
Jason
--- End quote ---
Damn Jason! I had no idea you were getting into CNC. Good luck with the build, be patient, the learning curve is worth it.
Unstupid:
--- Quote from: Jasonmm on January 04, 2012, 01:02:08 am ---
--- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS.
--- End quote ---
I got in early and got the TS guys all excited about the MechMate.
--- End quote ---
So wait... do the not have a CNC router at the Tech Shop?