| Main > Main Forum |
| Do all lcd/led tvs/monitors look like this when they are unframed ? |
| << < (3/3) |
| Jasonmm:
--- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS. --- End quote --- I got big plans ... plus I got CnC fever ... The TS is great, but its FAR (140 miles round trip/ gas money) and TS fee isnt cheap. I got in early and got the TS guys all excited about the MechMate. I am taking 13 classes and going at it .... I live in my forever home ... Do it right is my thinking ... Jason |
| Woodshop Flunky:
I think the Dallas/Ft Worth metro area would be a very profitable location for a TechShop. 8) |
| mountain:
--- Quote from: Jasonmm on January 04, 2012, 01:02:08 am --- --- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS. --- End quote --- I got big plans ... plus I got CnC fever ... The TS is great, but its FAR (140 miles round trip/ gas money) and TS fee isnt cheap. I got in early and got the TS guys all excited about the MechMate. I am taking 13 classes and going at it .... I live in my forever home ... Do it right is my thinking ... Jason --- End quote --- Damn Jason! I had no idea you were getting into CNC. Good luck with the build, be patient, the learning curve is worth it. |
| Unstupid:
--- Quote from: Jasonmm on January 04, 2012, 01:02:08 am --- --- Quote from: BobA on January 03, 2012, 07:03:44 pm ---Use the tech shop for all you can. Your effort to build a CNC will not e required until you surpass what the tech shop will allow you to do on their CNS. --- End quote --- I got in early and got the TS guys all excited about the MechMate. --- End quote --- So wait... do the not have a CNC router at the Tech Shop? |
| Navigation |
| Message Index |
| Previous page |