Main > Project Announcements
coffee table rotating control panel
Le Chuck:
--- Quote from: Kangum on January 27, 2012, 03:30:10 pm ---im glad you went with the first image for the background. it is the most balanced art. The other 2 while nice do not have good composition for the background.
--- End quote ---
Totally forgot about that, I was totally for A too. Glad you changed your wife's mind. ;D
segasega:
--- Quote from: menace on January 27, 2012, 11:40:00 am ---Some slow progress--finally got the adhesive vinyl--I ordered 4 pieces and they worked out to about $10 shipped each. The quality is fine for my needs. It was a hong kong company off ebay--was very happy with them overall.
Now on to wiring...
--- End quote ---
Mind sharing the name of the ebay seller, looking to get some cheap stuff done too. Cheers
leapinlew:
I vote A, if you can remove as much as the crotch plate as possible. Maybe put a "Wheres the beef" sticker on it.
menace:
--- Quote ---Mind sharing the name of the ebay seller, looking to get some cheap stuff done too. Cheers
--- End quote ---
they are prints-mart.
Not much progress, just got the buttons wired up but not wired to the encoder. For some reason I've been dragging my feet...I've also been mulling over a servo actuated q-bert mode on the rotating joystick in the middle.
Le Chuck:
Totally been playing with the same idea. I'd love to see what you come up with, my take is mounting the joy to a large thin gear then routing that into the CP as a bottom mount and having brackets with small ball bering feet to support the gear from the underside. That way with the servo you wouldn't even need an actuating arm, you can just put the post right against the gear. If alligned correctly the servo will prevent unplanned rotation.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version