Arcade Collecting > Pinball
Gameplan Sharpshooter-Roger takes the Girls to the Beauty Shop-update 9/20
Nephasth:
The LEP man needs a 3D printer. ;)
Good work though!
ChadTower:
You could cut one of those in 60 seconds, without the template, with a scroll saw.
I love my scroll saw. :)
TopJimmyCooks:
--- Quote from: Nephasth on August 26, 2012, 04:45:18 pm ---The LEP man needs a 3D printer. ;)
Good work though!
--- End quote ---
The LEP man does not turn down donations of High End Tools.
--- Quote from: pinballjim on August 26, 2012, 05:52:08 pm ---
I'll trade you a package of fresh flour tortillas. Sound good?
--- End quote ---
Not necessary- just pm me your address and I'll put a stamp on it.
--- Quote from: ChadTower on August 26, 2012, 06:43:13 pm ---
You could cut one of those in 60 seconds, without the template, with a scroll saw.
I love my scroll saw. :)
--- End quote ---
The actual cutting is about 60 seconds with the router. The template gives a better result when the goal is making consistent multiples. It minimizes the sanding as well- you only have to finish the edge rather than sanding each individual piece to the line. I had a nice scrollsaw in the Bureau of Wood Adjustment for a few years, but I just didn't use it enough to justify the space required. Also, this is a simple piece but it was also practice for the more complex Tommy VUK plastics I'm getting ready to run. I doubt the scrollsaw would help with the small protrusions on that plastic . :cheers:
yotsuya:
--- Quote from: TopJimmyCooks on August 26, 2012, 07:38:46 pm ---
--- Quote from: pinballjim on August 26, 2012, 05:52:08 pm ---
I'll trade you a package of fresh flour tortillas. Sound good?
--- End quote ---
Not necessary- just pm me your address and I'll put a stamp on it.
--- End quote ---
They're San Antonio tortillas, fool. You take them when offered.
ChadTower:
--- Quote from: TopJimmyCooks on August 26, 2012, 07:38:46 pm ---The actual cutting is about 60 seconds with the router.
--- End quote ---
'Actual cutting' is always 60 seconds. It's that 2 hours of prep time that'll get you.
The scroll saw is nice to have around when working on pins specifically for cutting plastics.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version