| Main > Main Forum |
| Wells Gardner 9200 27" digital (Wiring Question)-(pincusion re-visited) |
| << < (2/2) |
| lilshawn:
yes the top one usually is the "Focus" control and the bottom is the "screen" control. sometimes they will have 3, in which case, the top 2 will be focus and the bottom screen. the screen control basically controls the amount of high voltage is being spit out to the screen. more voltage, brighter picture... sort of |
| chillinwater:
Holy ---steaming pile of meadow muffin---!!! lilshawn, you just saved my Christmas!!! After my girlfriend kicked me out and I had the pincushion with the old board and blackscreen with the new... I was going to have to put my cab in storage and make me a sad panda. Had to jump through a few hoops -got the brightness adjusted but just said "no signal" on screen. wtf? -disconnected my (2) act lab guns to get a direct graphics card to monitor link, still "no signal" -then went to display properties, dont know what I did, just opened and closed the properties for the wg, clicked "OK" and it fired right up! Looks better then when I first bought the dang thing! I'll see about re-attaching the act labs but then again maybe not, I hate the way the screen flashes when you shoot and I know there are more modern gun solutions out there. I'm thinking a new Christmas present to myself thanks to you! You saved my Christmas!!! :notworthy: :cheers: :notworthy: Merry Christmas to you or whatever your pleasure!! |
| chillinwater:
Well this has been awhile but my problem has acted up again, actually shortly after the original fix... Since its related to the original issue I though id post here again. replaced-(deflection board, video neck board and remote control board) worked for a bit fixing the original pincusion problem but now I get "pincusion" again. Everything else is fine. I called Wells Gardner when it happened long ago and the guy mentioned that somthing may not be grounded. I will call him again but our schedules dont seem to match. I trust the gurus here more anyway :D So where do you think I start to look or test? In the power strip? (smart strip) Wall outlet? Chassis? Deflection board? loose wire somwhere? Back of tube at that rubber cup thingy? |
| Navigation |
| Message Index |
| Previous page |