Main > Main Forum
Looking to add more controls to my cocktail cabinet table build (w. pics!)
<< < (2/3) > >>
hamuelo:
Ok so I'm thinking the best way to do this would essentially be to wire in a whole separate set of controls along with the second jamma board, and then just pump it into the secondary input on the monitor, so all you gotta do is switch channels to play the other board.

So I'll essentially have two setups within the one cabinet.

But this throws up the problem - how do I power two boards/sets of controls from the one same power supply? Can you even do that?
Unstupid:
Just use a jamma switcher like this: http://www.jammaboards.com/store/2-in-1-multijamma-switcher-pcb-gbs-8118-/prod_324.html  or the 6 in 1... 
hamuelo:
Sure, but the problem is I need an entirely new set of controls for when you're sat in the 'horizontal' position. So I'm thinking the only way around it is to wire in an entire separate Jamma board - and harness - up to an entirely new pair of controls. So all I need to do now is power two setups from the same power supply. How would I do that?
Unstupid:
Why don't you just wire the 2 controllers to the same input?  So if you press up on the side controller it is the same as pressing up on the front controller. 
BobA:
There is no controller.  All he has is a 60 in 1 board that displays vertical games.  The controls go right to the 60 in 1 board.    As far as I see it you need a new control panel with the joystick or sticks and buttons to tie into your horizontal display and new jamma board.  It does not matter which board you chose you wil have to position yourself at the end of the cab to view the screen properly.
Navigation
Message Index
Next page
Previous page

Go to full version