Main > Project Announcements
Bob's Bartop Cabs. Completed 11/14/2011
BobA:
I am switching from Vertical monitors to Horizontal for a change. Here is the template and the resulting sides cut out. Darn pattern cutting bit threw the bearing so I just barely finished the sides. Should keep me busy this Winter. :D
Probably build them all with a new mini itx board and 17 or 19 inch monitor. Not 100% sure on the interface yet. I love ipacs, minipacs and keywiz but the xin mo and other new interfaces look good too.
equlizer:
been using the xin mo for just over a month now and no probs (yet) :afro: 2 player bartop, 9 buttons on each side
BobA:
I have one too but have not hooked it up. Used the 1 player version and it was fine. There are a few problem with the 1 player xin mo in usb ordering if you plug in a gamepad. It takes over and you need to use a program to reassign the keys or leave the gamepad connected so the usb order does not change. A 2 player would not have that problem as it is already 2 gamepads.
BobA:
Got 4 of the 6 cabinets fully cut but found a 1/2 inch error in the back so will have to cut a few more pieces. That is the problem with cutting in bulk. One error repeated 4 times. :( :( A bit smaller in depth than a weecade and has a different side profile. More like a Northcoast Customs Ultimate Bartop II but with less depth.
BobA:
This is the intel board I will be using is most of these cabs. D525MW ITX
Link for specs
Navigation
[0] Message Index
[#] Next page
Go to full version