Main > Main Forum

PCB problem.

Pages: << < (3/3)

equlizer:

To solve your problems, cut all the traces that lead to those pads.  So 2 traces per button you need to scrape.  I used a dremmel with a fine bit to do it.

Kore:


--- Quote from: equlizer on September 24, 2011, 08:15:59 pm ---To solve your problems, cut all the traces that lead to those pads.  So 2 traces per button you need to scrape.  I used a dremmel with a fine bit to do it.

--- End quote ---
Hi.

Thanks for the response.

Can you explain a little better you solution? Have you used this board for something similar?

I didn't understand the 2 traces per button thing.

Thanks.

equlizer:

 :banghead:  Ignore my last comment.   

Ya know what.  The guy above is correct, the best thing for you would be to find a common ground board.  Its really hard to explain otherwise. sorry :dunno

Pages: << < (3/3)

Go to full version