Main > Main Forum
PCB problem.
<< < (3/3)
equlizer:
To solve your problems, cut all the traces that lead to those pads.  So 2 traces per button you need to scrape.  I used a dremmel with a fine bit to do it.
Kore:

--- Quote from: equlizer on September 24, 2011, 08:15:59 pm ---To solve your problems, cut all the traces that lead to those pads.  So 2 traces per button you need to scrape.  I used a dremmel with a fine bit to do it.

--- End quote ---
Hi.

Thanks for the response.

Can you explain a little better you solution? Have you used this board for something similar?

I didn't understand the 2 traces per button thing.

Thanks.
equlizer:
 :banghead:  Ignore my last comment.   

Ya know what.  The guy above is correct, the best thing for you would be to find a common ground board.  Its really hard to explain otherwise. sorry :dunno
Navigation
Message Index
Previous page

Go to full version