Main > Main Forum

Illuminated Joystick

Pages: << < (8/33) > >>

nordemoniac:


--- Quote from: level42jeff on September 19, 2011, 11:29:41 am ---
--- Quote from: drventure on September 19, 2011, 11:24:50 am ---Ah, input board... Well, I went with the IPAC4 and have been unequivocally happy with it. Can't speak to the other options, but there are a few.

If you're doing a 2 player, you could go IPAC2 and save a few $$

--- End quote ---

I saw the iPac2 but I'm pretty sure its 2 inputs short for me (I want to add the two pinball buttons on the side) What kinda of price difference is there between the 2 and 4? and where can I order them?

--- End quote ---

Sorry if this has been said before;

You could just map those pinball buttons to a couple of the player 1/player 2 buttons you are not using while playing pinball?
So that you actually have to buttons two the same input on the IPAC 2, just different locations on your control panel?

cammada:

What is the dimension for Seimitsu LS-32, LS-32-01 and LS-32-02 shaft?

Are Seimitsu shaft same as Sanwa JLM-TM-8 shaft?

SSJ4Vegeta81:


--- Quote from: armi0024 on October 05, 2011, 04:50:52 am ---Good Grief what else do you want???? Lit bat tops? Fine Fine be that way!!! also on the way :)  But probably not before Xmas, sorry.

--- End quote ---

I hope this is true. I've been looking for someone who sells these because I'm planning on making a lit 4-player cp and really want bat-tops that light but have had no luck.

Will they be bubble or clear like that translucent ball-top?  If you make translucent blue I will definitely buy 4, and a matching ball-top for a dedicated 4-way. Of course, if it's bubble I'll still buy them.

Oh, and I plan on using Happ sticks if that matters.

Trip:


--- Quote from: RandyT on September 22, 2011, 03:04:08 pm ---We have a design that's been in the works for a while, but we don't have the resources at the moment to start producing them.

But....for those who want to "roll your own", it's a little known fact that the Versa-Ball Mirrored Stainless Ball-Top Joystick Shaft has a hollow shaft.  The special Electric ICE style knob runs about the same cost as the stainless knob, so those who want an EI joystick to put a standard sized LED (RGB or mono) can purchase one of these and leave in the comments that you would like the EI style knob.  Couple it with the SlipWire™ Swiveling Interconnect and you'll be all set.

RandyT

--- End quote ---

Are you still doing this or is there anyway possible to get the completed version?  If you got time and are ok with it, I would really like to talk to you off the forum in whatever communication method is most convenient for you.  I got a whole wad of stuff I would like to order from you when it becomes available and want to ask some questions.


Thanks

Tony555:

That translucent ball top looks awesome. I couldn't see them on Paradise Arcade Yet??

Would it be possible to buy the Paradise Arcade LED Joystick and throw on a translucent ball top and swap out the coloured LED with a IL-lumination RGB 5VDC LED???...All from Paradise!!!

Does this seem cheaper and easier than buying a standard joystick, a $15 hollow shaft, a balltop and an RGB LED??

Pages: << < (8/33) > >>

Go to full version