| Main > Main Forum |
| Control Panel method - simple |
| << < (2/3) > >> |
| Blanka:
I have the same corners, as they are dictated by the smallest CNC machine bit, 18mm. The only difference is that I route deeper, so the washers are under the CP. |
| Martijn:
Thnx, i was just arrived at this part, howto flush sink the bolts with the joystick plate. |
| Ond:
This weekend I got around to doing two more CP units for my mates cocktail cab. He's been waiting quite a while for these, I finally found time to work on them :). Here they are after primer coat in the spray tent. Still to do, sand back the primer and spray with a couple of coats of gloss black. |
| GregD:
What is the plate that you are using to cover the panels made out of? |
| Malenko:
looks amazing! I do kinda like the idea of routing a little deeper so the dust washers dont hide that awesome finish. |
| Navigation |
| Message Index |
| Next page |
| Previous page |