Arcade Collecting > Pinball

DMD Problem

<< < (2/3) > >>

MaineEvent:
Thanks for the input guys.
I haven't had time today to work on it again... I did look at the power board yesterday and didn't see any obvious sign of damage...
Yes, I put probably 1000 games on this without issue before the DMD had this problem.
Hopefully I can get something done tomorrow and let you know how it goes.

smartbomb2084:

--- Quote from: pinballjim on September 13, 2011, 07:45:12 pm ---I've had three Williams pins with similar issues and a HV rebuild kit cleared it up.


--- End quote ---

More Texas BS.

ChadTower:

--- Quote from: smartbomb2084 on September 14, 2011, 08:03:21 am ---
--- Quote from: pinballjim on September 13, 2011, 07:45:12 pm ---I've had three Williams pins with similar issues and a HV rebuild kit cleared it up.


--- End quote ---

More Texas BS.

--- End quote ---


I have had two Williams pins with this issue and an HV rebuild kit cleared it up.  One also needed a new DMD.  I have also done this for 3 other games that were not mine.

MaineEvent:
Alright,

I switched it on today... The DMD was still the same ---fouled up beyond all recognition--- up image for about 2 seconds, then it went back to normal.
I played for about 2 hours and didn't see a flicker or anything....WTF?
This isn't the Twilight Zone.....

Q*Bert_OP:

--- Quote from: pinballjim on September 14, 2011, 06:04:42 pm ---Guess the gas must have leaked back in.   ;)

--- End quote ---

 :lol

I have an outgassed DMD...It was dropped, the glass cracked, and the gas leaked out.  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page