| Main > Main Forum |
| Adding a volume control to some speakers |
| << < (5/5) |
| venom:
cheers Drnick. Have loads of crimps from my arcade cab restore. just for my clarity. Cut Both grounds that currently go to the two speakers lets call them A and B Then take one of these wires to pin 1 (A) Insulate the other wires of e.g in terminal block (B) i.e no need to connet to the l-pad. Then on the other pin 1 attach two wires and wire then speaker 1 ground and speaker 2 ground. So only using 3 wires in total. I looked at speakers today and both have 8 ohm 10 watt wrote on them so 15 watt is more than plenty may even see if they make 10 watt ones. |
| Navigation |
| Message Index |
| Previous page |