Main > Main Forum
12 volt coin mech jpac how do i connect it?
lostinarcade:
to coin mech i have is.
Wei-Ya Coin selector HI-07CS.
http://www.weiya.com.tw/products_detail.asp?le=english&fid=75&pid=90&tCatName=Front%20Inserting%20Type
Grey - counter +/-
Red - DC +12V
White - Coin Signal
Black - Ground
Grey - counter +/-
AndyWarne:
We sell those and they will work fine.
Andy
lostinarcade:
--- Quote from: AndyWarne on September 08, 2011, 02:41:44 pm ---We sell those and they will work fine.
Andy
--- End quote ---
thats good to know
thanks
southpaw13:
So how does it get wired? I had problems. How do you hook it up to a Ipac? Do you need a zener diode?
Thanks,
Southpaw
BobA:
Set the NO (normally open) jumper and connect the coin output to the input of your ipac or other controller.