| Main > Main Forum |
| 12 volt coin mech jpac how do i connect it? |
| << < (3/3) |
| lostinarcade:
to coin mech i have is. Wei-Ya Coin selector HI-07CS. http://www.weiya.com.tw/products_detail.asp?le=english&fid=75&pid=90&tCatName=Front%20Inserting%20Type Grey - counter +/- Red - DC +12V White - Coin Signal Black - Ground Grey - counter +/- |
| AndyWarne:
We sell those and they will work fine. Andy |
| lostinarcade:
--- Quote from: AndyWarne on September 08, 2011, 02:41:44 pm ---We sell those and they will work fine. Andy --- End quote --- thats good to know thanks |
| southpaw13:
So how does it get wired? I had problems. How do you hook it up to a Ipac? Do you need a zener diode? Thanks, Southpaw |
| BobA:
Set the NO (normally open) jumper and connect the coin output to the input of your ipac or other controller. |
| Navigation |
| Message Index |
| Previous page |