Software Support > GroovyMAME

Hi need help with my arcade monitor and groovy mame

<< < (5/5)

Calamity:

--- Quote from: lodoss118 on September 07, 2011, 04:45:12 pm ---Hi Calm, did what u said.

The resolutions seem to work now, but another problem i have that the games never stretch to the full screen? There are always borders when i run the games?

--- End quote ---

Borders above and below or left and righ?

lodoss118:
left and right

so [B [] B]

B = border :P

Calamity:

--- Quote from: lodoss118 on September 07, 2011, 05:14:30 pm ---left and right

so [B [] B]

B = border :P

--- End quote ---

Good. That can be fixed.

Run Arcade_OSD, select one mode, go to Horizontal Geometry, and dynamically adjust H Front Porch and H Back Porch until the picture fits the screen. You might need to adjust H Sync Pulse too. When you're ready, write down the values and edit the ones here with them:

monitor_specs_0 = "16200-18000, 49.50-65.00, 2.000, 4.700, 8.000, 0.064, 0.160, 1.056, 0, 0, 288, 448"
... in this order H Front Porch, H Sync Pulse, H Back Porch

Now, do this for one 16 kHz mode, one 25 KHz, and one 31 KHz mode, as the values will be different for each range, and edit each of your monitor specs line with the corresponding values.

Edit both vmmaker.ini and mame.ini.

Navigation

[0] Message Index

[*] Previous page

Go to full version