| Main > Main Forum |
| X-arcade problem |
| (1/1) |
| caskad:
Hello, i don't know if i'm rgight section but, will ask for help :) I try to connect (Mars ME111 13 pins, coin door), on buton 7, and i make a "boulette"... http://www.xgaming.com/support/questions/54/Advanced+BYO+Kit+installation+diagram+with+wiring+schematic. controller j6 is out.... buttons 3.6.7.8 doesn't respond att all .. :banghead: it m' not very good, so i test the 4 diode (led in english??) and there are OK with the multimeters (gives me 0.6 , i can't remember yet..) Is there a shema or someone who can guide me to correct test this? cheers |
| BobA:
Your Mars ME111 is powered by 12V. Your X arcade is 5V. Depending on what you connected to the X arcade controller you may have blown the inputs on j6. You did not provide into on what you connected so I am only guessing at this point. |
| gryhnd:
I just wired my coin door triggers to the buttons on my X-Arcade tank stick that simulate a coin drop. So when you put in a coin, the circuit completes and it's the same as the button being pressed. Requires no power at all from the door. After that I did also wire a hidden switch that breaks the button circuit so I can force use of the coin door only. Very simple wiring. |
| caskad:
Thx for explain, I've wiring on the fly and make a stupid mistake :badmood: controller j6 is out :banghead: rebuy one ! :censored: |
| Navigation |
| Message Index |