Main > Project Announcements
FINISHED - Here comes Peter Pepper - Burgertime Cabaret/Mini scratch build
shrunkenmaster:
--- Quote from: IG-88 on August 06, 2011, 08:37:05 am ---Could you explain how you did the "large format" print for the top part?
Your artwork is top notch also, care to share them with the rest of us?
--- End quote ---
Thanks my man. I saved the artwork (just the outlines) as a PDF and got it printed at a local shop that prints up to A0 size. They only print black & white line drawings at that size, which is fine for this.
Happy to share the artwork of course. Here's the Illustrator CS4 & PDF versions of the CPO/Marquee/Bezel (PM me for JPEGS) :
http://www.sendspace.com/file/glwxc3
mgb:
Very nice job so far. I'm looking forward to seeing the progress.
IG-88:
Thanks a lot for that! I'll PM you later for the jpegs. This should move my project right along now.
Couple more questions if I may. Do you still have the outlines pdf? I would like to try and take that to my local shop and see if they could do the same.
How did you decide on what size for them to print it at? IIRC the mock-up I did for my bartop was just a full size reduced by 2/3 and the upper-half "cut off" a few inches below the CP. Not sure if the side art would look right cut that way but I would really like to figure those curves correctly instead of just winging it.
shrunkenmaster:
--- Quote from: IG-88 on August 06, 2011, 12:17:59 pm ---Thanks a lot for that! I'll PM you later for the jpegs. This should move my project right along now.
Couple more questions if I may. Do you still have the outlines pdf? I would like to try and take that to my local shop and see if they could do the same.
How did you decide on what size for them to print it at? IIRC the mock-up I did for my bartop was just a full size reduced by 2/3 and the upper-half "cut off" a few inches below the CP. Not sure if the side art would look right cut that way but I would really like to figure those curves correctly instead of just winging it.
--- End quote ---
PM sent.
Woodshop Flunky:
This is terribly cool! You're a machine! :applaud:
How tall is this cab?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version