| Main > Main Forum |
| Router question? |
| (1/3) > >> |
| mytymaus007:
Is it possible to use a trim router for all routing needs to complete an Arcade cabinet if so any recomendations i found this one for cheap? I think Harbor Frieght has one also. Also what bits are used to recess the joysticks? http://www.google.com/products/catalog?q=trim+router&client=pub-5942360976771789&oe=ISO-8859-1&cof=GALT:%23003324%3BGL:1%3BDIV:%2366CC99%3BVLC:FF6600%3BAH:center%3BBGC:C5DBCF%3BLBGC:73B59C%3BALC:000000%3BLC:000000%3BT:330033%3BGFNT:333300%3BGIMP:333300%3BFORID:1&hl=en&um=1&ie=UTF-8&tbm=shop&cid=12614856202213355523&sa=X&ei=f_U5TvO8MIS10AH8s7nbAw&ved=0CFMQ8wIwAA# |
| upper2bits:
I would think so, as long as you can get the right bits for it everything should work fine. What type of wood are you using? |
| BobA:
Cutting joystick base holes etc will take a bit of setup because the router does not look like it has any depth control built in. You will just have to set your depth of cut on scrap pieces until it is correct. |
| mytymaus007:
what bit do you use for recessing the joysticks. I have the slot cutting bit. I use another bit for the holes with my drill. I just need to recess the sticks and trackball. |
| BobA:
I use a straight bit. Straight Bit |
| Navigation |
| Message Index |
| Next page |