Main > Main Forum
Any interest in original cab dimensions
<< < (9/69) > >>
paigeoliver:
So, Jakobud. Basically, if I go measure up my cabinets, and then make some basic drawings, and send you the info, then you can make up some plans?

Right on! With your OK, I will start measuring my Midway 8080 cabinet tommorrow.
Carsten Carlos:

--- Quote ---So, Jakobud. Basically, if I go measure up my cabinets, and then make some basic drawings, and send you the info, then you can make up some plans?


--- End quote ---

Yep, he helped me with drawing the sides of my Centipede-cab 18 months ago, thanx again! As you can see the final product turned out well :)
Jakobud:

--- Quote from: paigeoliver on September 16, 2003, 02:21:08 am ---So, Jakobud. Basically, if I go measure up my cabinets, and then make some basic drawings, and send you the info, then you can make up some plans?

Right on! With your OK, I will start measuring my Midway 8080 cabinet tommorrow.

--- End quote ---

Yeah exactly.  I can draw up whatever you want.  And then on my website I could easily make a little section dedicated to hosting all these plans.  I can host an actual Autocad file for each plan, and also maybe a PDF and JPEG or some vector format that everyone can read.
Birdtales:
I was going to try to do the autocad thing to the dimensions for the Joust Cocktail Edgedamage measured for us. I just can't seem to find the time. The measurements are here if you want to try to draw them out Jakobud.

http://www.birdtales.com/edge
Jakobud:
Birdtales,

I'm afraid I'm gonna need a little more than that.... or something different at least... In almost all those pictures I can't tell what part it is and I can't tell from where you are measuring from.. the easier thing to do would be to just draw some basic dimensions on a piece of paper, scan it and send it to me.  I will look again through those drawings but at first glance I couldnt tell what was what.
Navigation
Message Index
Next page
Previous page

Go to full version